It sounds like a lot but wear isn't really an issue in straight track segments, and generally takes years pretty much 100% of rail maintenance is done in curves. Lastly there was defect testing, where rail is tested internally for defects, that would also occur about twice a year. Rail profile affects fuel efficiency through friction and can also cause additional maintenance though so the rails would also be scanned more throroughly ahead of something called the "grinding train" which was another specialized train that reprofiled the rails, this was done from a hi-rail vehicle at about 10-25 mph. When a likely bad section of rail is found, a supervisor would go out and verify the wear with this, but usually the supervisor knows about it already cause it's been getting bad for years. Can only speak for freight in America, but no I never saw this specific device in their processes, on mainlines generally, the rail profile is checked with less precise methods at track speed using specialized trains with sensors installed on them, taking thousands of readings per minute.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |